When installing your jet ski decal kit, it is recommended that you are in a sealed and dry area with no breeze or dust and at temperatures above 60 degrees.
Make sure that the surface of your ski is completely clean and free of dirt, grease, and oils.
Be sure to use a squeegee and a spray bottle with application solution or slightly soapy water so that you can easily position your pieces into their places. A heat gun or hair dryer also helps to get rid of any unwanted wrinkles and helps the pieces lay down more effectively on curved surfaces. Be sure not to apply too much heat on one area, because it will melt and discolor the vinyl.
An X-acto knife or razor blade could be required, as some pieces may be slightly oversized for ease of installation, and could require trimming. Please note, that it is usually better to install the body pieces before logos to ensure proper alignments.
Important Note: Remember to go slow and be patient, if you try to rush the installation, you will definitely get a less than desirable result.